Wet Room Tanking, Fixing & Sealing Kit

A complete kit to install your wet room tray. Including flexible adhesive for bedding down the tray, a tanking kit for waterproofing and board fix for sealing the perimeter of the wet room tray.

Jackoboard Tanking Kit

Everything required to tank (waterproof) a wet room prior to tiling.

The Jackoboard tanking kit contains a rapid drying, brush/roller applied, single part flexible liquid membrane for use on rigid surfaces in bathrooms, wetrooms and showers. It can also be used to waterproof existing surfaces such as plaster, plasterboard or timber.

Suitable for all flat or vertical surfaces made of any material. Simple to use for novices and experts alike.
Compatible with almost every type of under floor heating and ready for tiling with no further preparation (please check with under floor heating manufacturer).

For use under ceramic coverings in wet rooms, showers and bathrooms.

Coverage 5 – 6sqm under normal conditions with recommended two coats.

Tub Containing:
4kg (2.5 litre) Tanking solution
1 litre primer for timber/plasterboard
10m sealing tape
2 x internal corners seals

Jackoboard Board Fix

Special adhesive and sealing agent for bonding insulation products such as construction boards, angle elements etc to a variety of substrates such as concrete, plaster, ceramic, glass, metal, wood and so on with outstanding adhesion. Solvent free and paintable.

Also used for sealing construction board joints in wet areas, suitable for use with WetBase^® trays and tile backer board.

Solvent free
For gluing JACKOBOARD® and JACKODUR®
For sealing JACKOBOARD® construction board joints in wet areas
Also suitable for use with WetBase^® trays and tile backer board
One cartridge is sufficient for about 9 running metres
Curing: 2mm adhesive bead i n 24hrs at +20°C.
Can be stored for 12 months.

Downloads:

Board-Fix data sheet
Board-Fix safety sheet

Rapidfix S1 Flexible Adhesive

Perfect for fixing down most types of wet room tray, including WetBase^® and Jackoboard, Britflex S1 Rapidset is supplied in a 10Kg bag, plenty for the largest of trays with a coverage of 1m² per 3.5kg when applied with a 3mm bead.

BRITFLEX S1 RAPIDSET is suitable for both matted and piped underfloor heating, in addition to use in wet areas.

Colour: WHITE

Specification:
– POLYMER MODIFIED
– HIGH STRENGTH
– RAPID SETTING
– NON SLIP
– INTERIOR & EXTERIOR
– WALL & FLOOR TILES
– BED THICKNESS 3-12MM
– UNDERFLOOR HEATING COMPATIBLE
– SUITABLE FOR PRE-STRENGTHENED WOODEN FLOORS
– SUITABLE FOR USE IN WET AREAS

POT LIFE = 40mins
GROUT AFTER = 2 hours

Downloads:
Declaration of Performance
Britflex S1 Rapidset Adhesive Datasheet

Please note:
Maximum purchase quantity is 1 kit, additional tanking kits and tubes of sealant can be purchased separately.