AKW FormSafe Wet Room Tanking Membrane 10m²

FormSafe is a unique bituminous, pre-formed flexible self-adhesive waterproof membrane. Consisting of a 1mm thick rubberised waterproof layer, incorporating a fabric mesh on one side.

FormSafe is probably one of the best tanking membranes available for use in wetroom applications as it provides a thick industrial strength impermeable barrier to any water that may escape beneath the tiles. The membrane is self-adhesive and comes on a roll. Once installed tiles can be applied immediately – there is no curing time.

Although particularly suited to floor applications FormSafe can also be applied to walls as an additional precaution. However, there is a maximum weight limit for wall mounted tiles when using FormSafe and this should not exceed 20kg/m2.

FormSafe can be used with under floor heating. Note: Maximum effective temperature for FormSafe is 32oC and should not be exceeded. Electrical heating max 150w.

10m Roll

At A Glance:

• It is ideal for use on substrates, such as timber, masonry, concrete, plasterboards, gypsum & tile backer boards
• Once Applied FormSafe is ready to tile immediately, no drying time
• Quick & easy to apply
• Factory controlled thickness
• Self-adhesive mat
• 100% waterproof
• No heating equipment required
• Can be installed over a thermal board.
• Heating restricted at 32°.
• Electrical heating max 150w.
• Lifetime of tile Guarantee

Contains:

• 10m² of FormSafe membrane (10m x 1m)
• 500ml FormSafe primer
• 10m Reinforcing tape
• 310ml Jointing compound

FormSafe Fitting Instructions (PDF)

Please note: AKW FormSafe is NOT compatible with the Wetrooms Online WetBase trays.